EasyManuals Logo

Cisco 2100 Series Configuration Guide

Cisco 2100 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
3-39
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 3 Configuring Ports and Interfaces
Configuring a 4400 Series Controller to Support More Than 48 Access Points
Figure 3-18 Interfaces > Edit Page
Step 5
Enter the appropriate interface parameters.
Note Do not define a backup port for an AP-manager interface. Port redundancy is not supported for
AP-manager interfaces. If the AP-manager interface fails, all of the access points connected to
the controller through that interface are evenly distributed among the other configured
AP-manager interfaces.
Step 6 To make the interface an AP-manager interface, check the Enable Dynamic AP Management check
box.
Step 7 Click Save Configuration to save your settings.
Step 8 Repeat this procedure for each additional AP-manager interface that you want to create.

Table of Contents

Other manuals for Cisco 2100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2100 Series and is the answer not in the manual?

Cisco 2100 Series Specifications

General IconGeneral
Power over Ethernet (PoE)No
Form FactorDesktop
EncryptionAES, TKIP
Maximum Access Points6
SecurityWPA, WPA2, 802.1X
Dimensions1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)

Related product manuals