Cisco 2100 Series Configuration Guide

CHAPTER
4-1
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
4
Configuring Controller SettingsWireless Device
Access
This chapter describes how to configure settings on the controllers. It contains these sections:
• Using the Configuration Wizard, page 4-2
• Using the AutoInstall Feature for Controllers Without a Configuration, page 4-6
• Managing the System Date and Time, page 4-10
• Configuring 802.11 Bands, page 4-14
• Configuring 802.11n Parameters, page 4-17
• Configuring DHCP Proxy, page 4-22
• Configuring Administrator Usernames and Passwords, page 4-23
• Configuring SNMP, page 4-24
• Changing the Default Values of SNMP Community Strings, page 4-25
• Changing the Default Values for SNMP v3 Users, page 4-27
• Configuring Aggressive Load Balancing, page 4-29
• Configuring Fast SSID Changing, page 4-31
• Enabling 802.3X Flow Control, page 4-31
• Configuring 802.3 Bridging, page 4-32
• Configuring Multicast Mode, page 4-34
• Configuring Client Roaming, page 4-40
• Configuring IP-MAC Address Binding, page 4-44
• Configuring Quality of Service, page 4-45
• Configuring Voice and Video Parameters, page 4-52
• Configuring EDCA Parameters, page 4-67
• Configuring Cisco Discovery Protocol, page 4-69
• Configuring RFID Tag Tracking, page 4-79
• Configuring and Viewing Location Settings, page 4-84
• Configuring the Supervisor 720 to Support the WiSM, page 4-89
• Using the Wireless LAN Controller Network Module, page 4-91

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)