Index
IN-29
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
ports 16-6
preempt delay time 16-5
primary edge port 16-4
ring segment 16-2
secondary edge port 16-4
segment characteristics 16-2
segments 16-1
SNMP traps, configuring 16-13
supported interfaces 16-1
SynceE workaround 6-2
SyncE workaround 6-2
triggering VLAN load balancing 16-5
verifying link integrity 16-3
VLAN blocking 16-12
VLAN load balancing 16-4
report suppression, IGMP
described 18-5
disabling 18-12
resequencing ACL entries 26-14
resets, in BGP 29-47
resetting a UDLD-shutdown interface 22-6
Resilient Ethernet Protocol
See REP
responder, IP SLAs
described 31-3
enabling 31-7
response time, measuring with IP SLAs 31-4
restricting access
NTP services 5-8
overview 8-1
passwords and privilege levels 8-2
RADIUS 8-17
TACACS+ 8-10
reverse address resolution 29-7
Reverse Address Resolution Protocol
See RARP
RFC
1112, IP multicast and IGMP 18-1
1157, SNMPv1 25-2
1305, NTP 5-2
1587, NSSAs 29-22
1757, RMON 23-2
1901, SNMPv2C 25-2
1902 to 1907, SNMPv2 25-2
2236, IP multicast and IGMP 18-1
2273-2275, SNMPv3 25-2
2475, DSCP 27-8
2597, AF per-hop behavior 27-8
2598, EF 27-8
4379 34-42
RIP
advertisements 29-17
authentication 29-20
configuring 29-18
default configuration 29-18
described 29-17
hop counts 29-17
summary addresses 29-21
support for 1-8
RMON
default configuration 23-3
displaying status 23-6
enabling alarms and events 23-3
groups supported 23-2
overview 23-1
statistics
collecting group Ethernet 23-5
collecting group history 23-5
support for 1-9
root guard
described 15-3
enabling 15-9
support for 1-5
root switch
MSTP 14-17
STP 13-14
route calculation timers, OSPF 29-30
route dampening, BGP 29-59
To Next Page
Loading...
