Cisco 7800 Series Administrator's Guide

CHAPTER 10
Cisco IP Phone Customization
•
Custom Phone Rings, page 105
•
Set Up Wideband Codec, page 107
•
Set Up Handset for 7811, page 108
•
Set Up Idle Display, page 108
•
Customize Dial Tone, page 109
Custom Phone Rings
The Cisco IP Phone ships with two default ring types that are implemented in hardware: Chirp1 and Chirp2.
Cisco Unified Communications Manager also provides a default set of additional phone ring sounds that are
implemented in software as pulse code modulation (PCM) files. The PCM files, along with an XML file
(named Ringlist-wb.xml) that describes the ring list options that are available at your site, exist in the TFTP
directory on each Cisco Unified Communications Manager server.
All file names are case sensitive. If you use ringlist-wb.xml for the file name, the phone will not apply
your changes.
Attention
For more information, see the documentation for your particular Cisco Unified Communications Manager
release.
Related Topics
Cisco Unified Communications Manager Documentation, on page xiii
Set Up Custom Phone Ring
To create custom phone rings for the Cisco IP Phone, perform these steps:
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
105

Cisco 7800 Series Specifications

General

Wireless	No
Video Support	No
PoE	Yes, 802.3af/at
Audio Codec Support	G.711, G.722, G.729, iLBC
Network Protocols	SIP, SDP, IPv4, IPv6, UDP, TCP, DNS, TFTP, HTTP, HTTPS, DHCP
Security Features	802.1X, TLS, SRTP
Power Options	PoE
Headset Port	3.5mm
Buttons	Line keys, navigation cluster, softkeys, mute, speakerphone, headset, volume control
Bluetooth	No
Ethernet Switch	Yes, 2-port 10/100/1000
USB Port	Yes, for headset (7875)