Description and Usage GuidelinesDefaultField Type
or Choices
Field Name
Allows the user to use the wideband codec for an analog
headset.
EnabledDisabled
Enabled
Wideband Headset UI
Control
Enables or disables the use of a Wideband Headset on the
phone. Used in conjunction with User Control Wideband
Headset.
For more information, see Set Up Wideband Codec, on page
107
EnabledDisabled
Enabled
Wideband Headset
Determines the sensitivity that the phone has for detecting a
connection failure to Cisco Unified Communications Manager
(Unified CM), which is the first step before device failover to
a backup Unified CM/SRST occurs.
• Normal—Detection of a Unified CM connection failure
occurs at the standard system rate. Choose this value for
faster recognition of a Unified CM connection failure.
• Delayed—Detection of a Unified CM connection failover
occurs approximately four times slower than Normal.
Choose this value if you prefer failover to be delayed
slightly to give the connection the opportunity to
reestablish
The precise time difference between Normal and Delayed
connection failure detection depends on many variables that
are constantly changing.
NormalNormal
Delayed
Detect Unified CM
Connection Failure
Controls custom features from Engineering Special (ES) loads.StringSpecial Requirement
ID
Specifies whether the serial console is enabled or disabled.DisabledDisabled
Enabled
Console Access
Controls the type of incoming call alert that displays on the
phone screen.
• Disabled—The actionable incoming call alert is disabled
and the user sees the traditional incoming call pop-up
alert.
• Show for all Incoming Call—The actionable incoming
call alert displays for all calls regardless of visibility.
• Show for Invisible Incoming Call—The actionable
incoming call alert displays for calls not shown on the
phone. This parameter behaves similarly to the incoming
call alert pop-up notification.
Show for all
Incoming Call
Disabled
Show for all Incoming
Call
Show for Invisible
Incoming Call
Actionable Incoming
Call Alert
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
141
Phone Feature Configuration
To Next Page
Loading...
Need help?
General
