Cisco 7906G Administration Guide

Chapter 3 Setting Up the Cisco Unified IP Phone
Configuring Security on the Cisco Unified IP Phone
3-18
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
To configure an LSC on the phone, follow these steps:
Procedure
Step 1 Obtain the CAPF authentication string that was set when the CAPF was
configured.
Step 2 From the phone, press the Menu button and choose Settings > Security
Configuration.
Note You can control access to the Settings Menu by using the Settings Access
field in the Cisco
Unified CallManager Administration Phone
Configuration Settings page. For more information, see
Cisco Unified CallManager Administration Guide.
Step 3 Press **# to unlock settings on the Security Configuration menu.
Step 4 Scroll to LSC and press the Update softkey.
The phone prompts for an authentication string.
Step 5 Enter the authentication code and press the Submit softkey.
The phone begins to install, update, or remove the LSC, depending on how the
CAPF was configured. During the procedure, a series of messages appears in the
LSC option field in the Security Configuration menu so that you can monitor
progress. When the procedure completes successfully, the phone will display
Installed or Not Installed.
The LSC install, update, or removal process can take a long time to complete. You
can stop the process at any time by pressing the Stop softkey from the Security
Configuration menu. (Settings must be unlocked before you can press this
softkey).

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English