Cisco 7906G Administration Guide

4-13
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
SW Port
Configuration
Speed and duplex of the network
port (labeled 10/100 SW). Valid
values:
• Auto Negotiate
• 10 Half—10-BaseT/half
duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half
duplex
• 100 Full—100-BaseT/full
duplex
If the phone is connected to a
switch, configure the port on the
switch to the same speed/duplex as
the phone, or configure both to
auto-negotiate.
If you change the setting of this
option, you must change the PC
Port Configuration option to the
same setting. (applies to 7911G
only)
1. Unlock network configuration options.
2. Scroll to the SW Port Configuration
option and then press the Edit softkey.
3. Scroll to the setting that you want and
then press the Select softkey.
4. Press the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English