Cisco 7906G Administration Guide

7-9
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Status Menu
Error Verifying
Config Info
The name-based and default
configuration file was not
found on the TFTP Server.
The configuration file for a phone is created
when the phone is added to the
Cisco
Unified CallManager database. If the
phone has not been added to the
Cisco
Unified CallManager database, the
TFTP server generates a
CFG File Not Found
response.
• Phone is not registered with
Cisco
Unified CallManager.
You must manually add the phone to
Cisco
Unified CallManager if you are not
allowing phones to auto-register. See the
“Adding Phones to the
Cisco Unified CallManager Database”
section on page 2-12 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses, check
configuration of the TFTP server. See the
“Network Configuration Menu” section
on page 4-7 for details on assigning a
TFTP server.
Table 7-2 Status Messages on the Cisco Unified IP Phone 7906G and 7911G (continued)
Message Description Possible Explanation and Action

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English