Cisco 7906G Administration Guide

Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Status Menu
7-12
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
No CTL installed A CTL file is not installed in
the phone.
Occurs if security is not configured or, if
security is configured, because the CTL file
does not exist on the TFTP server.
For more information, refer to
Cisco
Unified CallManager Security Guide.
No default router DHCP or static configuration
did not specify a default
router.
• If the phone has a static IP address, verify
that the default router has been
configured. See the
“Network
Configuration Menu” section on page 4-7
section for details.
• If you are using DHCP, the DHCP server
has not provided a default router. Check
the DHCP server configuration.
No DNS server IP A name was specified but
DHCP or static IP
configuration did not specify a
DNS server address.
• If the phone has a static IP address, verify
that the DNS server has been configured.
See the
“Network Configuration Menu”
section on page 4-7 section for details.
• If you are using DHCP, the DHCP server
has not provided a DNS server. Check the
DHCP server configuration.
Programming Error The phone failed during
programming.
Attempt to resolve this error by power cycling
the phone. If the problem persists, contact
Cisco technical support for additional
assistance.
Successful – MD5 The phone attempted an
802.1X transaction and
authentication achieved.
The phone achieved 802.1X authentication.
For more information, see the “802.1X
Authentication and Status” section on
page 4-36.
Table 7-2 Status Messages on the Cisco Unified IP Phone 7906G and 7911G (continued)
Message Description Possible Explanation and Action

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English