DescriptionDefaultField Type
Or Choices
Field Name
Defines the length of time that the phone is idle before
the backlight turns off. Applies only when the backlight
was off as scheduled and was turned on by a user (by
pressing a button on the phone or lifting the handset).
For example, to turn the backlight off when the phone
is idle for 1 hour and 30 minutes after a user turns the
backlight on, enter 01:30.
See Set Up Power Save.
hh:mmBacklight Idle Timeout
Turns the backlight on when there is an incoming call.EnabledDisabled
Enabled
Backlight On When
Incoming Call
Defines the schedule of days for which the phone
powers off.
Choose the day or days from the drop-down list. To
choose more than one day, Ctrl+click each day that
you want.
When Enable Power Save Plus is turned on, you
receive a message that warns about emergency (e911)
concerns.
While Power Save Plus Mode (the “Mode”)
is in effect, endpoints that are configured
for the mode are disabled for emergency
calling and from receiving inbound calls.
By selecting this mode, you agree to the
following: (i) You take full responsibility
for providing alternate methods for
emergency calling and receiving calls while
the mode is in effect; (ii) Cisco has no
liability in connection with your selection
of the mode and all liability in connection
with enabling the mode is your
responsibility; and (iii) You fully inform
users of the effects of the mode on calls,
calling and otherwise.
Caution
To disable Power Save Plus, you must uncheck the
Allow EnergyWise Overrides check box. If the Allow
EnergyWise Overrides remains checked but no days
are selected in the Enable Power Save Plus field, Power
Save Plus is not disabled.
See Set Up EnergyWise.
Days of the weekEnable Power Save Plus
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
95
Cisco IP Conference Phone Administration
Product Specific Configuration
To Next Page
Loading...
