Appendix C Connecting to DC Power
Wiring the DC-Input Power Source
C-6
Catalyst 2950 Desktop Switch Hardware Installation Guide
78-11157-05
Caution You must connect the Catalyst 2950G-24-EI-DC or Catalyst 2950ST-24 LRE 997
switch only to a DC-input power source that has an input supply voltage from –36
to –72 VDC. If the supply voltage is not in this range, the switch might not operate
properly or might be damaged.
Caution The switch must be installed with 5A-branch-circuit protection.
Note This installation must comply with all applicable codes.
To wire the switch to a DC-input power source, follow these steps:
Step 1 Locate the terminal block plug (see Figure C-4).
Figure C-4 Terminal Block Plug
60530
To Next Page
Loading...
