Cisco Catalyst 2950 Hardware Installation Guide

Contents
vi
Catalyst 2950 Desktop Switch Hardware Installation Guide
78-11157-05
Entering the Initial Configuration Information 1-6
IP Settings 1-6
Completing the Setup Program 1-6
Connecting to an Ethernet Port 1-10
Accessing the Switch from Your Browser 1-11
Recommended Platform Configuration for Web-Based Management 1-12
Operating System and Browser Support 1-12
Guidelines for Installing and Enabling the Java Plug-In 1-13
Installing the Required Java Plug-In 1-14
CHAPTER 2 Overview 2-1
Features 2-1
Front-Panel Description 2-4
10/100 Ports 2-9
10/100/1000 Ports 2-10
100BASE-FX and 1000BASE-SX Ports 2-11
LRE Port 2-12
GBIC Module Ports 2-13
SFP Module Slots 2-14
SFP Modules 2-15
LEDs 2-17
System LED 2-20
RPS LED 2-21
Port Mode and Port Status LEDs 2-21
Rear-Panel Description 2-27
Power Connectors 2-29
Internal Power Supply Connector 2-29
DC Power Connector 2-30
Cisco RPS Connector 2-30

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz