B-52
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform ip igmp snooping
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ip igmp snooping command is the same as the no debug platform ip igmp
snooping command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
rpc [cfg | l3mm | misc
| vlan]
Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
• cfg—(Optional) Display IGMP snooping RPC debug messages.
• l3mm—(Optional) IGMP snooping Layer 3 multicast router group RPC
debug messages.
• misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
• vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
warn Display IGMP snooping warning messages.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
debug ip igmp
snooping
Displays information about platform-independent IGMP snooping activity.
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General