Cisco Catalyst 3560X-24P User Manual

2-95
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
clear ip arp inspection log
clear ip arp inspection log
Use the clear ip arp inspection log privileged EXEC command on the switch stack or on a standalone
switch to clear the dynamic Address Resolution Protocol (ARP) inspection log buffer.
clear ip arp inspection log
Syntax Description This command has no arguments or keywords.
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Examples This example shows how to clear the contents of the log buffer:
Switch# clear ip arp inspection log
You can verify that the log was cleared by entering the show ip arp inspection log privileged command.
Related Commands
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
arp access-list Defines an ARP access control list (ACL).
ip arp inspection log-buffer Configures the dynamic ARP inspection logging buffer.
ip arp inspection vlan
logging
Controls the type of packets that are logged per VLAN.
show inventory log Displays the configuration and contents of the dynamic ARP
inspection log buffer.

Cisco Catalyst 3560X-24P Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24
Power over Ethernet (PoE)	Yes
Stacking	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Voltage Required	100-240V AC
Operating Temperature	32 to 113°F (0 to 45°C)
Jumbo Frame Support	Yes
Routing Protocol	OSPF, RIP, EIGRP
Remote Management Protocol	SNMP, SSH, Telnet
Features	Quality of Service (QoS), VLAN support, Access Control Lists (ACLs)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Humidity	10% to 90% non-condensing
Management	SNMP
Model	Cisco Catalyst 3560X-24P
Uplink Ports	4
MAC Address Table Size	16K