2-150
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
diagnostic start
diagnostic start
Use the diagnostic start privileged EXEC command to run an online diagnostic test.
diagnostic start switch number test {name | test-id | test-id-range | all | basic | non-disruptive}
Syntax Description
Defaults This command has no default setting.
Command Modes Privileged EXEC
Command History
Usage Guidelines The switch supports these tests:
ID Test Name [On-Demand Test Attributes]
--- -------------------------------------------
1 TestPortAsicStackPortLoopback [B*N****]
2 TestPortAsicLoopback [B*D*R**]
3 TestPortAsicCam [B*D*R**]
4 TestPortAsicRingLoopback [B*D*R**]
5 TestMicRingLoopback [B*D*R**]
6 TestPortAsicMem [B*D*R**]
7 TestInlinePwrCtlr [B*D*R**]
--- -------------------------------------------
switch number Specify the switch number, which is the stack member number. If the
switch is a standalone switch, the switch number is 1. If the switch is in a
stack, the range is 1 to 9, depending on the switch member numbers in the
stack.
This keyword is supported only on on stacking-capable switches.
test Specify the tests to run.
name Specify the name of a test. For more information, see the “Usage
Guidelines” section.
test-id Specify the ID number of a test. The range is from 1 to 7. For more
information, see the “Usage Guidelines” section.
test-id-range Specify more than one test with the range of test ID numbers. For more
information, see the “Usage Guidelines” section.
all Specify all the diagnostic tests.
basic Specify the basic on-demand diagnostic tests.
non-disruptive Specify the nondisruptive health-monitoring tests.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General