Cisco Catalyst 3560X-24P User Manual

C-40
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix C Catalyst 3750-X and 3560-X Show Platform Commands
show platform stp-instance
show platform stp-instance
Use the show platform stp-instance privileged EXEC command to display platform-dependent
spanning-tree instance information.
show platform stp-instance vlan-id [ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
vlan-id Display spanning-tree instance information for the specified VLAN. The range
is 1 to 4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3560X-24P Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24
Power over Ethernet (PoE)	Yes
Stacking	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Voltage Required	100-240V AC
Operating Temperature	32 to 113°F (0 to 45°C)
Jumbo Frame Support	Yes
Routing Protocol	OSPF, RIP, EIGRP
Remote Management Protocol	SNMP, SSH, Telnet
Features	Quality of Service (QoS), VLAN support, Access Control Lists (ACLs)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Humidity	10% to 90% non-condensing
Management	SNMP
Model	Cisco Catalyst 3560X-24P
Uplink Ports	4
MAC Address Table Size	16K