2-526
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show cisp
show cisp
Use the show cisp privileged EXEC command to display CISP information for a specified interface.
show cisp {[interface interface-id] | clients | summary} | {[begin | exclude | include} expression]}
Syntax Description
Command Modes Global configuration
Command History
Examples This example shows output from the show cisp interface command:
WS-C3750E-48TD#show cisp interface fast 0
CISP not enabled on specified interface
This example shows output from the show cisp summary command:
CISP is not running on any interface
Related Commands
clients (Optional) Display CISP client details
interface interface-id (Optional) Display CISP information about the specified interface. Valid
interfaces include physical ports and port channels.
summary (Optional) Display
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
dot1x credentials profile Configure a profile on a supplicant switch
cisp enable Enable Client Information Signalling Protocol (CISP)
To Next Page
Loading...
Need help?
General