2-718
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show mls qos vlan
show mls qos vlan
Use the show mls qos vlan user EXEC command to display the policy maps attached to a switch virtual
interface (SVI).
show mls qos vlan vlan-id [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines The output from the show mls qos vlan command is meaningful only when VLAN-based quality of
service (QoS) is enabled and when hierarchical policy maps are configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mls qos vlan command:
Switch> show mls qos vlan 10
Vlan10
Attached policy-map for Ingress:pm-test-pm-2
Related Commands
vlan-id Specify the VLAN ID of the SVI to display the policy maps. The range is 1 to
4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
policy-map Creates or modifies a policy map that can be attached to
multiple ports and enters policy-map configuration mode.
To Next Page
Loading...
Need help?
General