2-737
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show power inline
show power inline
Use the show power inline user EXEC command to display the Power over Ethernet (PoE) status for the
specified PoE port, the specified stack member, or for all PoE ports in the switch stack.
show power inline [interface-id | consumption | module switch-number] [police] [priority] [ |
{begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
interface-id (Optional) Display PoE-related power management information for the
specified interface.
consumption (Optional) Display the power allocated to devices connected to PoE ports.
module switch-number (Optional) Limit the display to ports on the specified stack member. The
switch number is 1 to 9.
This keyword is supported only on stacking-capable switches.
police (Optional) Display the power policing information about real-time power
consumption.
priority (Optional) Display the power inline port priority for each port.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
