Cisco Catalyst 3560X-24P User Manual

2-330
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
logging event
logging event
Use the logging event interface configuration command to enable notification of interface link status
changes. Use the no form of this command to disable notification.
logging event {bundle-status | link-status | spanning-tree | status | trunk status}
no logging event {bundle-status | link-status | spanning-tree | status | trunk status}
Syntax Description
Defaults Event logging is disabled.
Command Modes Interface configuration
Command History
Examples This example shows how to enable spanning-tree logging:
Switch(config-if)# logging event spanning-tree
bundle-status Enable notification of BUNDLE and UNBUNDLE messages.
link-status Enable notification of interface data link status changes.
power-inline status See the logging event power-inline-status command.
spanning-tree Enable notification of spanning-tree events.
status Enable notification of spanning-tree state change messages.
trunk-status Enable notification of trunk-status messages.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3560X-24P Specifications

General

Brand	Cisco
Model	Catalyst 3560X-24P
Category	Switch
Language	English