EasyManuals Logo

Cisco Catalyst 3560X-24P User Manual

Cisco Catalyst 3560X-24P
1188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #898 background imageLoading...
Page #898 background image
2-866
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
switchport
switchport
Use the switchport interface configuration command with no keywords on the switch stack or on a
standalone switch to put an interface that is in Layer 3 mode into Layer 2 mode for Layer 2 configuration.
Use the no form of this command to put an interface in Layer 3 mode.
switchport
no switchport
Use the no switchport command (without parameters) to set the interface to the routed-interface status
and to erase all Layer 2 configurations. You must use this command before assigning an IP address to a
routed port.
Note This command (with no keywords) is not supported on switches running the LAN base feature set.
Syntax Description This command has no arguments or keywords.
Defaults By default, all interfaces are in Layer 2 mode.
Command Modes Interface configuration
Command History
Usage Guidelines Entering the no switchport command shuts the port down and then re-enables it, which might generate
messages on the device to which the port is connected.
When you put an interface that is in Layer 2 mode into Layer 3 mode (or the reverse), the previous
configuration information related to the affected interface might be lost, and the interface is returned to
its default configuration.
Note If an interface is configured as a Layer 3 interface, you must first enter this switchport command with
no keywords to configure the interface as a Layer 2 port. Then you can enter additional switchport
commands with keywords, as shown on the pages that follow.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3560X-24P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3560X-24P and is the answer not in the manual?

Cisco Catalyst 3560X-24P Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3560X-24P
CategorySwitch
LanguageEnglish

Related product manuals