Cisco Catalyst 3560X-24P

2-560
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show dot1q-tunnel
show dot1q-tunnel
Use the show dot1q-tunnel user EXEC command to display information about IEEE 802.1Q tunnel
ports.
show dot1q-tunnel [interface interface-id] [ | {begin | exclude | include} expression]
Note This command is not supported on switches running the LAN base feature set.
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples These are examples of output from the show dot1q-tunnel command:
Switch> show dot1q-tunnel
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Gi1/0/6
Po2
Switch> show dot1q-tunnel interface gigabitethernet1/0/1
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
interface interface-id (Optional) Specify the interface for which to display IEEE 802.1Q tunneling
information. Valid interfaces include physical ports and port channels.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.