2-861
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
switch priority
switch priority
Use the switch priority global configuration command on the stack master to change the stack member
priority value.
switch stack-member-number priority new-priority-value
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description
Defaults The default priority value is 1.
Command Modes Global configuration
Command History
Usage Guidelines The new priority value is a factor during a stack-master re-election. Therefore, changing the priority
value does not change the stack master immediately.
Examples This example shows how to change the priority value of stack member 6 to 9:
Switch(config)# switch 6 priority 9
Changing the Switch Priority of Switch Number 6 to 9
Do you want to continue?[confirm]
Related Commands
stack-member-number Specify the current stack member number. The range is 1 to 9.
priority new-priority-value Specify the new stack member priority value. The range is 1 to 15.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
reload Reloads the stack member and puts a configuration change into effect.
session Accesses a specific stack member.
switch renumber Changes the stack member number.
show switch Displays information about the switch stack and its stack members.
To Next Page
Loading...
Need help?
General