C-13
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Appendix C Catalyst 3750-X and 3560-X Show Platform Commands
show platform ip unicast
show platform ip unicast
Use the show platform ip unicast privileged EXEC command to display platform-dependent IP unicast
routing information.
show platform ip unicast {adjacency | cef-idb | counts | dhcp | failed {adjacency | arp [A.B.C.D]
| route} | loadbalance | mpaths | proxy | route | rpf {A.B.C.D {A.B.C.D} | stats interface-id}
standby | statistics | table | trace} [ | {begin | exclude | include} expression]
Note This command is not supported on switches running the LAN base feature set.
Syntax Description adjacency Display the platform adjacency database.
cef-idb Display platform information corresponding to Cisco Express Forwarding
(CEF) interface descriptor block.
counts Display the current counts for the Layer 3 unicast databases.
dhcp Display the DHCP system dynamic addresses.
failed {adjacency |
arp [A.B.C.D] | route}
Display the hardware resource failures. The keywords have these meanings:
• adjacency—Display the adjacency entries that failed to be programmed
in hardware.
• arp—Display the Address Resolution Protocol (ARP) deletions because
of failure and because of retries.
• A.B.C.D—(Optional) Prefix of the ARP entries to display.
• route—Display the route entries that failed to be programmed in
hardware.
loadbalance Display the platform load-balance database.
mpaths Display the Layer 3 unicast routing multipath adjacency database.
proxy Display the platform proxy ARP database.
route Display the platform route database.
rpf {A.B.C.D
{A.B.C.D} | stats
interface-id}
Display the unicast reverse path forwarding (unicast RPF) platform
information. The keywords have these meanings:
• A.B.C.D {A.B.C.D}—Prefix and prefix mask of the RPF entries to
display.
• stats—Display the unicast RPF statistics for the specified interface.
standby Display the platform standby information.
statistics Display the Layer 3 unicast routing accumulated statistics.
table Display the platform IP version 4 (IPv4) information.
trace Display the platform event trace logs.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.