Cisco Catalyst 3560X-24P User Manual

2-639
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show ipv6 mld snooping
show ipv6 mld snooping
Use the show ipv6 mld snooping user EXEC command to display IP version 6 (IPv6) Multicast Listener
Discovery (MLD) snooping configuration of the switch or the VLAN.
show ipv6 mld snooping [vlan vlan-id] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Use this command to display MLD snooping configuration for the switch or for a specific VLAN.
VLAN numbers 1002 through 1005 are reserved for Token Ring and FDDI VLANs and cannot be used
in MLD snooping.
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show ipv6 mld snooping vlan command. It shows snooping
characteristics for a specific VLAN.
Switch> show ipv6 mld snooping vlan 100
Global MLD Snooping configuration:
-------------------------------------------
MLD snooping : Enabled
MLDv2 snooping (minimal) : Enabled
Listener message suppression : Enabled
TCN solicit query : Disabled
TCN flood query count : 2
Robustness variable : 3
Last listener query count : 2
Last listener query interval : 1000
Vlan 100:
--------
MLD snooping : Disabled
MLDv1 immediate leave : Disabled
vlan vlan-id (Optional) Specify a VLAN; the range is 1 to 1001 and 1006 to 4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3560X-24P Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24
Power over Ethernet (PoE)	Yes
Stacking	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Voltage Required	100-240V AC
Operating Temperature	32 to 113°F (0 to 45°C)
Jumbo Frame Support	Yes
Routing Protocol	OSPF, RIP, EIGRP
Remote Management Protocol	SNMP, SSH, Telnet
Features	Quality of Service (QoS), VLAN support, Access Control Lists (ACLs)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Humidity	10% to 90% non-condensing
Management	SNMP
Model	Cisco Catalyst 3560X-24P
Uplink Ports	4
MAC Address Table Size	16K