2-579
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show etherchannel
show etherchannel
Use the show etherchannel user EXEC command to display EtherChannel information for a channel.
show etherchannel [channel-group-number {detail | port | port-channel | protocol | summary}]
{detail | load-balance | port | port-channel | protocol | summary} [ | {begin | exclude |
include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines If you do not specify a channel-group, all channel groups are displayed.
In the output, the Passive port list field is displayed only for Layer 3 port channels. This field means that
the physical port, which is still not up, is configured to be in the channel group (and indirectly is in the
only port channel in the channel group).
Note Layer 3 port channels are not supported when the switch is running the LAN base feature set.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
channel-group-number (Optional) Number of the channel group. The range is 1 to 48.
detail Display detailed EtherChannel information.
load-balance Display the load-balance or frame-distribution scheme among ports in the
port channel.
port Display EtherChannel port information.
port-channel Display port-channel information.
protocol Display the protocol that is being used in the EtherChannel.
summary Display a one-line summary per channel-group.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General