Cisco Catalyst 3560X-24P User Manual

2-34
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
authentication host-mode
This example shows how to enable single-host mode on a port:
Switch(config-if)# authentication host-mode single-host
You can verify your settings by entering the show authentication privileged EXEC command.
Related Commands Command Description
authentication
control-direction
Configures the port mode as unidirectional or bidirectional.
authentication event Sets the action for specific authentication events.
authentication
fallback
Configures a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication
authentication open Enables or disable open access on a port.
authentication order Sets the order of authentication methods used on a port.
authentication
periodic
Enables or disable reauthentication on a port.
authentication
port-control
Enables manual control of the port authorization state.
authentication
priority
Adds an authentication method to the port-priority list.
authentication timer Configures the timeout and reauthentication parameters for an
802.1x-enabled port.
authentication
violation
Configures the violation modes that occur when a new device connects to a
port or when a new device connects to a port after the maximum number of
devices are connected to that port.
show authentication Displays information about authentication manager events on the switch.

Cisco Catalyst 3560X-24P Specifications

General

Brand	Cisco
Model	Catalyst 3560X-24P
Category	Switch
Language	English