Cisco Catalyst 3560X-24P User Manual

2-724
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show mvr interface
In the preceding display, Status is defined as follows:
• Active means the port is part of a VLAN.
• Up/Down means that the port is forwarding/nonforwarding.
• Inactive means that the port is not yet part of any VLAN.
This is an example of output from the show mvr interface command for a specified port:
Switch# show mvr interface gigabitethernet1/0/2
Type: RECEIVER Status: ACTIVE Immediate Leave: DISABLED
This is an example of output from the show mvr interface interface-id members command:
Switch# show mvr interface gigabitethernet1/0/2 members
239.255.0.0 DYNAMIC ACTIVE
239.255.0.1 DYNAMIC ACTIVE
239.255.0.2 DYNAMIC ACTIVE
239.255.0.3 DYNAMIC ACTIVE
239.255.0.4 DYNAMIC ACTIVE
239.255.0.5 DYNAMIC ACTIVE
239.255.0.6 DYNAMIC ACTIVE
239.255.0.7 DYNAMIC ACTIVE
239.255.0.8 DYNAMIC ACTIVE
239.255.0.9 DYNAMIC ACTIVE
Related Commands Command Description
mvr (global configuration) Enables and configures multicast VLAN registration on the
switch.
mvr (interface configuration) Configures MVR ports.
show mvr Displays the global MVR configuration on the switch.
show mvr members Displays all receiver ports that are members of an MVR
multicast group.

Cisco Catalyst 3560X-24P Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24
Power over Ethernet (PoE)	Yes
Stacking	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Voltage Required	100-240V AC
Operating Temperature	32 to 113°F (0 to 45°C)
Jumbo Frame Support	Yes
Routing Protocol	OSPF, RIP, EIGRP
Remote Management Protocol	SNMP, SSH, Telnet
Features	Quality of Service (QoS), VLAN support, Access Control Lists (ACLs)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Humidity	10% to 90% non-condensing
Management	SNMP
Model	Cisco Catalyst 3560X-24P
Uplink Ports	4
MAC Address Table Size	16K