Cisco Catalyst 3560X-24P

2-742
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
show power inline
This is an example of output from the show power inline police interface-id command on a standalone
switch.
Switch> show power inline priority
Interface Admin Oper Priority
State State
---------- ------ ---------- --------
Gi3/0/1 auto off low
Gi3/0/2 auto off low
Gi3/0/3 auto off low
Gi3/0/4 auto off low
Gi3/0/5 auto off low
Gi3/0/6 auto off low
Gi3/0/7 auto off low
Gi3/0/8 auto off low
Gi3/0/9 auto off low
Gi3/0/10 auto off low
Gi3/0/11 auto off low
Gi3/0/12 auto off low
Gi3/0/13 auto off low
Gi3/0/14 auto off low
Gi3/0/15 auto off low
Gi3/0/16 auto off low
Gi3/0/17 auto off low
Gi3/0/18 auto off low
Gi3/0/19 auto off low
Gi3/0/20 auto off low
Gi3/0/21 auto off low
Related Commands
Cutoff Power The maximum power allocated on the port. When the real-time power
consumption is greater than this value, the switch takes the configured policing
action.
Oper Power The real-time power consumption of the powered device.
1. The configured power is the power that you manually specify or that the switch specifies by using CDP power negotiation or
the IEEE classification, which is different than the real-time power that is monitored with the power sensing feature. The
configured power values on a Catalyst 3750-X, Catalyst 3750-E, Catalyst 3650-X, or Catalyst 3560-E switch is the same as
the actual power values on a Catalyst 3750 or 3560 switch.
Table 2-47 show power inline police Field Descriptions (continued)
Field Description
Command Description
logging event
power-inline-status
Enables the logging of PoE events.
power inline Configures the power management mode for the specified PoE port or for all
PoE ports.
show controllers
power inline
Displays the values in the registers of the specified PoE controller.