Cisco Firepower 4100 Command Reference

install platform
To upgrade firmware and software on the security platform components, use the install platform command.
install platform platform-vers version_number
Syntax Description
Specifies the version of the platform package to install.platform-vers
version_number
Command Modes
Auto install (/firmware/auto-install) mode
Command History
ModificationRelease
Command added.1.4(1)
Usage Guidelines
You must have administrator privileges to use this command. The upgrade process typically takes between
20 and 30 minutes.
Before initiating installation, review the current critical/major faults and back up the current configuration.
You can use the show fsm status expand command in auto-install mode to monitor the installation process.
To complete the upgrade installation process, you must acknowledge the pending reboot of the primary
fabric-interconnect.
Example
This example shows how to install a platform upgrade package:
FP9300-A# scope firmware
FP9300-A /firmware # scope auto-install
FP9300-A /firmware/auto-install # install platform platform-vers 2.3(1.51)
The currently installed FXOS platform software package is 2.2(2.19)
INFO: There is no service impact to install this FXOS platform software 2.3(1.51)
This operation upgrades firmware and software on Security Platform Components
Here is the checklist of things that are recommended before starting Auto-Install
(1) Review current critical/major faults
(2) Initiate a configuration backup
Do you want to proceed? (yes/no):
Related Commands
DescriptionCommand
Downloads an FXOS software image to the Firepower 4100/9300 chassis.download image
Displays the status of the image verification process.show validate-task
Cisco Firepower 4100/9300 FXOS Command Reference
105
A – R Commands
install platform

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English