Cisco Firepower 4100 Command Reference

set http-proxy-server-port
To set the HTTP/HTTPS proxy server port for Smart Software Licensing and Smart Call Home, use the set
http-proxy-server-port command.
set http-proxy-server-port port_number
Syntax Description
The port for the HTTP or HTTPS proxy server; range is 1 to 65535.
port_number
Command Default
The HTTP/HTTPS proxy is disabled by default. The proxy must be enabled before you enter the server address
and port number.
Command Modes
Callhome mode
Usage Guidelines
If your network uses an HTTP proxy for Internet access, you must enable the proxy and configure its address
for Smart Software Licensing. This proxy is also used for Smart Call Home in general.
Example
This example shows how to enter an HTTP/HTTPS proxy-server port number:
FP9300-A# scope monitoring
FP9300-A /monitoring # scope callhome
FP9300-A /monitoring/callhome # set http-proxy-server-port 443
FP9300-A /monitoring/callhome #
Related Commands
DescriptionCommand
Enables or disables the HTTP/HTTPS proxy for Smart Software Licensing
and Smart Call Home.
set
http-proxy-server-enable
Sets the HTTP/HTTPS address for the proxy server.set http-proxy-server-url
Cisco Firepower 4100/9300 FXOS Command Reference
190
S Commands
set http-proxy-server-port

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English