Cisco Firepower 4100 Command Reference

set http-proxy-server-enable
To enable or disable an HTTP/HTTPS proxy for Smart Software Licensing and Smart Call Home, use the set
http-proxy-server-enable command.
set http-proxy-server-enable {off|on}
Syntax Description
Disables the Smart Call Home HTTP/HTTPS proxy.off
Enables the Smart Call Home HTTP/HTTPS proxy.on
Command Default
The HTTP/HTTPS proxy is disabled by default.
Command Modes
Callhome mode
Usage Guidelines
If your network uses an HTTP proxy for Internet access, you must enable the proxy and configure its address
for Smart Software Licensing. This proxy is also used for Smart Call Home in general.
Example
This example shows how to enable an HTTP proxy:
FP9300-A# scope monitoring
FP9300-A /monitoring # scope callhome
FP9300-A /monitoring/callhome # set http-proxy-server-enable on
FP9300-A /monitoring/callhome #
Related Commands
DescriptionCommand
Sets the HTTP or HTTPS address of the proxy server.set http-proxy-server-url
Sets the communications port for the proxy server.set http-proxy-server-port
Cisco Firepower 4100/9300 FXOS Command Reference
189
S Commands
set http-proxy-server-enable

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English