Cisco Firepower 4100

scope fan-module
To enter a specific fan module, use the scope fan-module command in chassis mode.
scope fan-module {1 module_id}
Syntax Description
The tray_id is always 1.tray_id
Identifies the specific fan module to enter; value can be 1 through 8.
module_id
Command Modes
scope chassis/
Command History
ModificationRelease
Command added.1.1(1)
Example
This example shows how to scope into fan-module mode:
firepower# scope chassis
firepower /chassis # scope fan-module 1 2
firepower /chassis/fan-module #
Related Commands
DescriptionCommand
Scopes into a specific fan.scope fan
Cisco Firepower 4100/9300 FXOS Command Reference
137
S Commands
scope fan-module