Cisco Firepower 4100 Command Reference

show sel
To display the contents of the system event log (SEL) for a server, use the show sel command.
show sel server_id
Syntax Description
The server identifier, expressed as chassis-number/server-number (rack ID is
not a valid option).
server_id
Command Modes
Any command mode
Command History
ModificationRelease
Command added.1.1(1)
Example
This example shows how to display the contents of the SEL for server 1 in chassis 1:
FP9300-A# show sel 1/1
show sel 1/1
1 | 12/16/2015 23:09:55 | CIMC | Event Logging Disabled DDR4_
P2_H2_ECC #0x99 | Log Area Reset/Cleared | | Asserted
2 | 12/16/2015 23:09:56 | CIMC | Processor P2_THERMTRIP_N #0x
7a | Limit Not Exceeded | Asserted
3 | 12/16/2015 23:09:57 | CIMC | Processor P1_THERMTRIP_N #0x
79 | Limit Not Exceeded | Asserted
4 | 12/16/2015 23:10:00 | CIMC | Platform alert LED_SYS_ACT #
0xa4 | LED is on | Asserted
5 | 12/16/2015 23:10:00 | CIMC | Platform alert LED_SYS_ACT #
0xa4 | LED color is green | Asserted
6 | 12/16/2015 23:10:01 | CIMC | Processor DDR4_P2_H3_TMP #0x
73 | Limit Not Exceeded | Asserted
7 | 12/16/2015 23:10:01 | CIMC | Platform alert LED_LOM_FAULT
#0xa3 | LED is off | Asserted
8 | 12/16/2015 23:10:01 | CIMC | Platform alert LED_LOM_FAULT
#0xa3 | LED color is blue | Asserted
9 | 12/16/2015 23:10:03 | CIMC | Processor DDR4_P2_H2_TMP #0x
72 | Limit Not Exceeded | Asserted
--More--
<--- remaining lines removed for brevity --->
FP9300-A#
Related Commands
DescriptionCommand
Enters server mode.scope server
Cisco Firepower 4100/9300 FXOS Command Reference
325
S Commands
show sel

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English