Cisco Firepower 4100 Command Reference

set remote-subnet
To specify the remote subnet for an IPSec tunnel connection, use the set remote-subnet command.
set remote-subnet ip_address/mask_bits
Syntax Description
Provide an IPv4 or IPv6 remote subnet address/mask for the IPSec connection;
maximum of 510 characters.
ip_address/mask_bits
Command Modes
Connection (/security/ipsec/connection) mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use this command to specify the IP address/mask of an IPSec connectionʼs remote subnet.
Example
This example shows how to set the remote subnet for an IPSec connection:
FP9300-A # scope security
FP9300-A /security # scope ipsec
FP9300-A /security/ipsec # enter connection testconn
FP9300-A /security/ipsec/connection # set remote-subnet 209.165.202.128/27
FP9300-A /security/ipsec/connection* # commit-buffer
FP9300-A /security/ipsec/connection #
DescriptionCommand
Creates a new IPSec connection.create connection
Sets the remote IP address for an IPSec connection.set remote-addr
Cisco Firepower 4100/9300 FXOS Command Reference
220
S Commands
set remote-subnet

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English