Cisco Firepower 4100 Command Reference

set http-proxy-server-url
To set the HTTP/HTTPS proxy server address for Smart Software Licensing and Smart Call Home, use the
set http-proxy-server-url command.
set http-proxy-server-url url
Syntax Description
The HTTP or HTTPS address of the proxy server; can be a maximum of 2083
characters.
url
Command Default
The HTTP/HTTPS proxy is disabled by default. The proxy must be enabled before you enter the server address.
Command Modes
Callhome mode
Usage Guidelines
If your network uses an HTTP proxy for Internet access, you must enable the proxy and configure its address
for Smart Software Licensing. This proxy is also used for Smart Call Home in general.
Example
This example shows how to enter an HTTPS proxy-server address:
FP9300-A# scope monitoring
FP9300-A /monitoring # scope callhome
FP9300-A /monitoring/callhome # set http-proxy-server-url https://209.165.201.10
FP9300-A /monitoring/callhome #
Related Commands
DescriptionCommand
Enables or disables the HTTP/HTTPS proxy for Smart Software Licensing
and Smart Call Home.
set
http-proxy-server-enable
Sets the communications port for the proxy server.set http-proxy-server-port
Cisco Firepower 4100/9300 FXOS Command Reference
191
S Commands
set http-proxy-server-url

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English