Cisco Firepower 4100 Command Reference

connect adapter
To connect to the adapter command shell, use the connect command.
connect adapter {chassis/server/id | rack_server/id}
Syntax Description
Specifies the chassis, server (module) and adapter IDs (entered in n/n/n format).
On the Firepower 9300, the module number can be 1, 2, or 3. On the Firepower
4100, it is 1.
The chassis ID number is always 1.
Note
chassis/server/id
Specifies the rack number and module ID (entered in n/n format).
rack_server/id
Command Modes
Any command mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Use help to list available mezzanine adapter commands; use help command to view information about an
individual command.
Refer to connect adapter: Command List, on page 392 for additional information.
To exit the adapter mode, enter exit.
Example
The following example shows how to connect to the adapter command shell, and view available
commands:
firepower# connect adapter 1/1/1
adapter 1/1/1 # help
Available commands:
connect - Connect to remote debug shell
exit - Exit from subshell
help - List available commands
history - Show command history
show-fwlist - Show firmware versions on the adapter
show-identity - Show adapter identity
show-phyinfo - Show adapter phy info
show-systemstatus - Show adapter status
adapter 1/1/1 # exit
firepower#
Related Commands
DescriptionCommand
Returns you to the previous CLI mode.exit
Cisco Firepower 4100/9300 FXOS Command Reference
37
A – R Commands
connect adapter

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English