Cisco Firepower 4100 Command Reference

connect cimc
To connect to the Cisco Integrated Management Controller (CIMC) command shell, use the connect cimc
command.
connect cimc {chassis_id/blade_id | rack_id}
Syntax Description
Specifies the chassis and module numbers (entered in n/n format).
The chassis ID number is always 1.
Note
chassis_id/blade_id
Specifies the rack number.
rack_id
Command Modes
Any command mode
Command History
ModificationRelease
Command added.1.1(1)
Usage Guidelines
Enter help to list available CIMC firmware debug utility commands; enter help command to view information
about an individual command. Enter exit to terminate the utility. Do not use this utility unless instructed to
do so by Cisco TAC. Refer to connect cimc: Command List, on page 394 for additional information.
Example
The following example shows how to connect to cimc mode and then list the available commands:
firepower# connect cimc 1/1
Trying 127.5.1.1...
Connected to 127.5.1.1.
Escape character is '^]'.
CIMC Debug Firmware Utility Shell [ support ]
[ help ]# help
__________________________________________
Debug Firmware Utility
__________________________________________
Command List
__________________________________________
alarms
cores
dimmbl
exit
i2cstats
images
mctools
memory
messages
mrcout
network
obfl
post
power
Cisco Firepower 4100/9300 FXOS Command Reference
40
A – R Commands
connect cimc

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English