Cisco Firepower 4100

Additional InformationCommand
System management commands
hap-reset - Enables resetting of local or remote sup on ha failures
heartbeat - Enables heartbeat
no - Negate a command or set its defaults
system
Set terminal line parameters; see the following tableterminal
Test command
aaa - Aaa authentication
eltm - Display eltm information
forwarding - Fib information
hardware - Test hardware parameters
otv
test
Disable Debugging functions (See also debug)
all - Disable all debugging
icmpv6 - ICMPv6 debug commands
ip - IP events
ipv6 - IPv6 events
l2 - Layer2
l3vm - Debug L3VM information
pktmgr - Packet manager debug/tunnel information
rpm - Route Policy Manager (RPM)
sockets - Sockets
system - Enable debugging of system components
undebug
Go to exec modeend
Exit from command interpreterexit
Pop mode from stack or restore from name
name – Name (optional)
pop
Push current mode to stack or save it under name
name – Name (optional)
push
Shows the cli context you are in
detail – Shows each entry on separate line (optional)
where
Cisco Firepower 4100/9300 FXOS Command Reference
397
connect shell Commands
connect fxos: Command List