ATA Routing Field Reference
WAN Status page
Cisco Small Business ATA Administration Guide 105
A
MAC Clone Settings section
A MAC address is a 12-digit code assigned to a unique piece of hardware for
identification, like a social security number. Some ISPs require you to register a
MAC address in order to access the Internet. If you do not wish to re-register the
MAC address with your ISP, you may assign the MAC address you have currently
registered with your ISP to the router with the MAC Address Clone feature.
Remote Management section
QOS Settings section
Use Quality of Service (QoS) to assign different priority levels to different types of
data transmissions.
Enable MAC Clone
Service
To use MAC Address cloning, select Yes. Default is No.
Cloned MAC Address Use when your ISP requires a certain MAC address. Its
usually the address for your PC.
Enable WAN Web
Server
Allows or prevents access to the administration web
server from a computer that is not directly connected to
the ATA device. Options are Yes or No. The default
value is Yes.
WAN Web Server Port The port that is used for WAN access to the ATA device.
The default value is 80.
QOS Policy Enable when you want to use QoS. Options are: Always
On or On when Phone is Use (default).
QOS QDisc Allow QoS Queuing. Options are None or TBF (token
bucket filter). Information can be found at about TBF at:
http://lartc.org/howto/lartc.qdisc.classless.html
To Next Page
Loading...
Need help?
General
