ATA Voice Field Reference
PSTN Line page (SPA3102)
Cisco Small Business ATA Administration Guide 206
B
VoIP-To-PSTN Gateway Setup section
VoIP-To-PSTN
Gateway Enable
Enable or disable VoIP-To-PSTN Gateway functionality.
The default is yes.
VoIP Caller
Authentication
Method
Method to be used to authenticate a VoIP Caller to access
the PSTN gateway. Choose from {none, PIN, HTTP Digest.
The default is none.
VoIP PIN Max Retry Number of trials to allow VoIP caller to enter a PIN number
(used only if authentication method is set to PIN).
The default is 3.
One Stage Dialing Enable one-stage dialing (applicable if authentication
method is none, or HTTP Digest, or caller is in the Access
List).
The default is yes.
Line 1 VoIP Caller
DP
Index of the dial plan in the dial plan pool to be used when
the VoIP Caller is calling from Line 1 of the same SPA3102
unit during normal operation (in other words, not due to
fallback to PSTN service when Line 1 VoIP service is
down). Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}
Authentication is skipped for Line 1 VoIP caller.
The default is 1.
Default VoIP Caller
DP
Index of the dial plan in the dial plan pool to be used when
the VoIP Caller is not authenticated. Choose from {none, 1,
2, 3, 4, 5, 6, 7, 8}.
The default is 1.
Line 1 Fallback DP Index of the dial plan in the dial plan pool to be used when
the VoIP Caller is calling from Line 1 of the same SPA3102
unit due to fallback to PSTN service when Line 1 VoIP
service is down. Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}.
The default is 1.
To Next Page
Loading...
Need help?
General
