Cisco SPA2102 - Changing the Music File for the Internal Music Source

Configuring Music on Hold
Using the Internal Music Source for Music On Hold
Cisco Small Business ATA Administration Guide 82
5
STEP 2 Start Internet Explorer, and then enter the IP address of the telephone. The
Telephone Configuration page appears in a separate browser window.
STEP 3 Click , and then click .
STEP 4 Click the tab.
STEP 5 Scroll down to the section.
STEP 6 Enter the following value in the field:
STEP 7 Click .
STEP 8 To verify, place a test call to the extension. When the call is answered and put on
hold, the caller should hear the default music file ( ).
Changing the Music File for the Internal Music Source
The following resources are required to change the music file for the internal music
source:
 TFTP server software
 The IP address of the administration computer that is connected to the
SPA9000
 A music source in G.711u format, sampled at 8000 samples/sec, up to 65.5
seconds in length, with no header information
STEP 1 Before you begin, make sure that you have TFTP server software running on your
computer.
STEP 2 Start Internet Explorer, connect to the administration web server, and choose
Admin access with Advanced settings.
STEP 3 Click Voice tab > .
STEP 4 Scroll down to the section.
STEP 5 Enter the following URL in the Internal Music URL field:
 server_IPaddress: The local IP address of the computer you are using as the
TFTP server
 port: The port number used by the TFTP server (default