ATA Voice Field Reference
System page
Cisco Small Business ATA Administration Guide 121
B
Miscellaneous Settings section (not used with PAP2T)
DNS Server Order Specifies the method for selecting the DNS server. The
options are Manual (enter the IP address of the DNS server
manually; that is do not look at the DHCP-supplied DNS
table), Manual/DHCP, and DHCP/Manual.
DNS Query Mode Do parallel or sequential DNS Query. With parallel DNS
query mode, the ATA device sends the same request to all
the DNS servers at the same time when doing a DNS
lookup, the first incoming reply is accepted by the ATA
device.
The default is parallel.
Syslog Server Specify the syslog server name and port. This feature
specifies the server for logging ATA device system
information and critical events. If both Debug Server and
Syslog Server are specified, Syslog messages are also
logged to the Debug Server.
Debug Server The debug server name and port. This feature specifies
the server for logging ATA device debug information. The
level of detailed output depends on the debug level
parameter setting.
Debug Level The higher the debug level, the more debug information is
generated. Zero (0) means no debug information is
generated. To log SIP messages, Debug Level must be set
to at least 2.
The default is 0.
Primary NTP
Server
IP address or name of primary NTP server.
Secondary NTP
Server
IP address or name of secondary NTP server.
Syslog Server Specifies the IP address of the syslog server.
Debug Server Specifies the IP address of the debug server, which logs
debug information. The level of detailed output depends on
the debug level parameter setting.
To Next Page
Loading...
Need help?
General
