Cisco SPA2102 User Manual

ATA Voice Field Reference
User page
Cisco Small Business ATA Administration Guide 219
B
Supplementary Service Settings section
The ATA device provides native support of a large set of enhanced or
supplementary services. All of these services are optional. The parameters listed
in the following table are used to enable or disable a specific supplementary
service. A supplementary service should be disabled if a) the user has not
subscribed for it, or b) the Service Provider intends to support similar service
using other means than relying on the ATA device.
CW Setting Call Waiting on/off for all calls.
The default is yes.
Block CID Setting Block Caller ID on/off for all calls.
The default is no.
Block ANC Setting Block Anonymous Calls on or off.
The default is no.
DND Setting DND on or off.
The default is no.
CID Setting Caller ID Generation on or off.
The default is yes.
CWCID Setting Call Waiting Caller ID Generation on or off.
The default is yes.
Dist Ring Setting Distinctive Ring on or off.
The default is yes.
Secure Call Setting If yes, all outbound calls are secure calls by default.
The default is no.
Message Waiting This value is updated when there is voice mail notification
received by the ATA device. The user can also manually
modify it to clear or set the flag. Setting this value to yes
can activate stutter tone and VMWI signal. This parameter
is stored in long term memory and will survive after reboot
or power cycle.
The default is no.

Cisco SPA2102 Specifications

General

Brand	Cisco
Model	SPA2102
Category	Adapter
Language	English