ATA Voice Field Reference
Regional page
Cisco Small Business ATA Administration Guide 141
B
Control Timer Values (sec) section
CWT Frequency Frequency script of the call waiting tone. All distinctive
CWTs are based on this tone.
The default is 440@-10.
Synchronized Ring If this is set to Yes, when a device calls the Linksys ATA,
both lines ring at the same time (similar to a regular PSTN
line). After one line answers, the other stops ringing. This
field is only found in the PAP2T. No is the default.
Hook Flash Timer
Min
Minimum on-hook time before off-hook qualifies as hook-
flash. Less than this the on-hook event is ignored. Range:
0.10.4 seconds.
The default is 0.1.
Hook Flash Timer
Max
Maximum on-hook time before off-hook qualifies as hook-
flash. More than this the on-hook event is treated as on-
hook (no hook-flash event). Range: 0.41.6 seconds.
The default is 0.9.
Callee On Hook
Delay
Phone must be on-hook for at this time in sec before the
ATA device will tear down the current inbound call. It does
not apply to outbound calls. Range: 0255 seconds.
The default is 0.
Reorder Delay Delay after far end hangs up before reorder tone is played.
0 = plays immediately, inf = never plays. Range: 0255
seconds.
The default is 5.
Call Back Expires Expiration time in seconds of a call back activation. Range:
065535 seconds.
The default is 1800.
Call Back Retry
Intvl
Call back retry interval in seconds. Range: 0255 seconds.
The default is 30.