Cisco SPA2102 User Manual

ATA Voice Field Reference
Regional page
Cisco Small Business ATA Administration Guide 143
B
Vertical Service Activation Codes section
Vertical Service Activation Codes are automatically appended to the dial-plan.
There is no need to include them in dial-plan, although no harm is done if they are
included.
CPC Duration Duration in seconds for which the tip-to-ring voltage is
removed after the caller hangs up. After that, tip-to-ring
voltage is restored and dial tone applies if the attached
equipment is still off-hook. CPC is disabled if this value is
set to 0. Range: 0 to 1.000 second. Resolution is 0.001
second.
The default is 0 (CPC disabled).
Call Return Code This code calls the last caller.
The default is *69.
Call Redial Code Redials the last number called. This field is not found in the
PAP2T.
The default is *07.
Blind Transfer Code Begins a blind transfer of the current call to the extension
specified after the activation code.
The default is *98.
Call Back Act Code Starts a callback when the last outbound call is not busy.
The default is *66.
Call Back Deact
Code
Cancels a callback.
The default is *86.
Call Back Busy Act
Code
Starts a callback when the last outbound call is busy. This
field is only found in the PAP2T.
The default is *05
Cfwd All Act Code Forwards all calls to the extension specified after the
activation code.
The default is *72.

Cisco SPA2102 Specifications

General

Brand	Cisco
Model	SPA2102
Category	Adapter
Language	English