ATA Voice Field Reference
SIP page
Cisco Small Business ATA Administration Guide 122
B
SIP page
You can use the Voice tab > SIP page to configure the SIP settings. With some
variations, depending on the model, this page includes the following sections:
SIP Parameters section section on page 122
SIP Timer Values (sec) section section on page 124
Response Status Code Handling section section on page 126
RTP Parameters section section on page 127
SDP Payload Types section section on page 129
NAT Support Parameters section section on page 130
Trunking Parameters section (SPA8000) section on page 133
SIP Parameters section
Debug Level Determines the level of debug information that is
generated. Select 0, 1, 2, or 3 from the drop-down menu.
The higher the debug level, the more debug information is
generated.
The default is 0, which indicates that no debug information
is generated.
Max Forward SIP Max Forward value, which can range from 1 to 255.
The default is 70.
Max Redirection Number of times an invite can be redirected to avoid an
infinite loop.
The default is 5.
Max Auth Maximum number of times (from 0 to 255) a request may
be challenged.
The default is 2.
To Next Page
Loading...
