Cisco SPA2102 - Page 178

ATA Voice Field Reference
Line page
Cisco Small Business ATA Administration Guide 178
B
PSTN-To-VoIP Gateway Setup section (SPA8800)
VoIP Caller Default
DP
Index of the dial plan in the dial plan pool to be used as the
default. Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}.
The default is 1.
Line 1 Fallback DP Index of the dial plan in the dial plan pool to be used when
the VoIP Caller is calling from Line 1 of the same SPA8800
unit due to fallback to PSTN service when Line 1 VoIP
service is down. Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}.
The default is 1.
PSTN CID for VoIP
CID
Choose yes or no.
The default is no.
PSTN CID Number
Prefix
The prefix to add to the caller ID number on the PBX to
ensure that a callback goes to the correct number.
Enter the digits.
PSTN caller Default
DP
Index of the dial plan in the dial plan pool to be used when
the PSTN Caller is not authenticated. Choose from {1, 2, 3, 4,
5, 6, 7, 8}.
The default is 1.
Line 1 Signal Hook
Flash to PSTN
The operation of the hook flash on the analog phone when
a PSTN-to-VoIP call is active.
Choose Disabled or Double Hook Flash.
The default is Disabled.
PSTN CID Name
Prefix
The prefix to add to the caller ID name that is sent to the
PBX.
Enter the characters to add to the caller ID name.