Configuring VPN
VeriSign™ Identity Protection configuration
Cisco SA500 Series Security Appliances Administration Guide 169
7
NOTE
1. The Change Password section is available only for users who belong to the local
data base.
2. The administrator can enable or disable certain features.
3. The user must ensure that Java, Java Script, Active-X controls are enabled or
allowed in the web browser settings.
VeriSign™ Identity Protection configuration
Use this page to configure the optional VeriSign™ Identity Protection (VIP) two-
factor authentication to authenticate SSL VPN users, providing an enhanced level
of security.
NOTE For more information or to order the VeriSign Identity Protection service, go to:
www.cisco.com/go/viptoken.
Configuring VeriSign Identity Protection
STEP 1 Click VPN > VeriSign ID Protection > VIP Configuration.
The VIP Configuration window opens.
STEP 2 To activate or disable your service, complete the following tasks in the VeriSign
Identity Protection Configuration area:
a. Enable VeriSign Identity Protection: Check this box to enable VIP, or uncheck
the box to disable this feature.
b. Service Type: Choose the type of service that you acquired from VeriSign:
• VIP Pilot/Developer Test Drive: Choose this option if pilot tokens were
provided to you to test and understand VIP service during the initial stages
of deployment.
• VIP Production: Choose this option if you have purchased VeriSign service.
The service will use VIP production servers to authenticate your users.
c. Click Apply to save your settings.
To Next Page
Loading...
Need help?
General
