Networking
Configuring IPv6 Addressing
Cisco SA500 Series Security Appliances Administration Guide 77
2
Configuring IPv6 Addressing
Internet Protocol Version 6 (IPv6) is a new IP protocol designed to replace IPv4,
the Internet protocol that is predominantly deployed and extensively used
throughout the world. IPv6 quadruples the number of network address bits from
32 bits (in IPv4) to 128 bits, resulting in an exponentially larger address space. You
can configure the security appliance to support IPv6 addressing on the LAN and
the Dedicated WAN.
NOTE IPv6 is not supported on the Optional port.
First enable IPv6 mode, and then configure your WAN connection, LAN connection,
routing, and tunneling.
• IP Routing Mode
• Configuring the IPv6 WAN Connection
• Configuring the IPv6 LAN
• IPv6 LAN Address Pools
• IPv6 Multi LAN
• IPv6 Static Routing
• Routing (RIPng)
• 6to4 Tunneling
• IPv6 Tunnels Status
• ISATAP Tunnels
• MLD Tunnels
• Configuring Router Advertisement
• Adding RADVD Prefixes
To Next Page